Non-Conservative Forces

As you read, pay attention to Figure 7.15 for a comparison of conservative and non-conservative forces. In Figure 7.15 (a), a rock is being "bounced" on an ideal spring with no friction. The mechanical energy does not change, and the rock will continue bouncing indefinitely. In Figure 7.15 (b), the rock is thrown and lands on the ground. When it hits the ground, its kinetic energy is converted to thermal energy and sound. The rock can not "bounce" back up because its mechanical energy is not conserved.

Gravity is a good example of a conservative force we use a lot in physics. Gravitational force is a conservative force because the work gravity does on an object does not depend on the path the object takes. Consequently, gravity is a good candidate to add into the work-energy theorem, where work is only done by gravity: $W=Fd=mad$

Since the acceleration due to gravity is simply $g$ and the direction of motion due to gravity is in the y-axis, we can further build the equation that represents work due to gravity: $W=mg(\Delta y)=\Delta(mgy)$

Previously, we have discovered that work is also equal to the change in kinetic energy (see Section 7.2). So, we can now combine our equation for work due to gravity and our equation for work with respect to the change in kinetic energy: $\Delta(mgy)=\Delta(\frac{1}{2})mv^{2}$ . The $mgy$ in the equation is called the gravitational potential energy. We define potential energy as stored energy due to a system's position: $PE=mgy$ .

Nonconservative Forces and Friction

Forces are either conservative or nonconservative. Conservative forces were discussed in Conservative Forces and Potential Energy. A nonconservative force is one for which work depends on the path taken. Friction is a good example of a nonconservative force. As illustrated in Figure 7.14, work done against friction depends on the length of the path between the starting and ending points. Because of this dependence on path, there is no potential energy associated with nonconservative forces. An important characteristic is that the work done by a nonconservative force adds or removes mechanical energy from a system. Friction, for example, creates thermal energy that dissipates, removing energy from the system. Furthermore, even if the thermal energy is retained or captured, it cannot be fully converted back to work, so it is lost or not recoverable in that sense as well.

(a) A drawing of a happy face is erased diagonally from a point A to a point B. (b) A drawing of a happy face is erased in the shape of the letter u, but starting from the same point A and ending at the same point B.

Figure 7.14 The amount of the happy face erased depends on the path taken by the eraser between points A and B, as does the work done against friction. Less work is done and less of the face is erased for the path in (a) than for the path in (b). The force here is friction, and most of the work goes into thermal energy that subsequently leaves the system (the happy face plus the eraser). The energy expended cannot be fully recovered.

Source: Rice University, https://openstax.org/books/college-physics/pages/7-5-nonconservative-forces
This work is licensed under a Creative Commons Attribution 4.0 License.